Mazda 5 1.6hdi проблем, Адаптация на дюзи Опции

[ifancho]

First to say Hi all. I dont speak russian so i hope i`ll be excuse.
I had to change 1 injector (hopefully will be enough). I did with Forscan a:
1. Pilot injection reset
2. High pressure reset
3. Egr reset
Originally had 4 mistakes for adaptation max reached and error for low pressure in 1 cylinder.
The motor was really shaking bad on cold. Was shaking after the swap of the 1st injector. Yesterday i did the above 3 resets and drove for 20km wiht the 2500-1500 method. Turned off the engine and back on again. Drove back home but the injectors knocked bad at the beginning. Felt better in the end. Then this morning the motor was not shaking too much.
It concerns me that i cant see the pid 0-7 for adaptation and dont know if i did right. Still heraing knocking in front at midrange rpms.

Anyone knows if this is working on Mazda 5 2011 - https://www.youtube.com/watch?v=AeE-Z5J2wMk&t=32s